Tip wheel set for left and right wing
The housing is made of solid plastics, not GFK, finished in white 2K/PU paint.

Dimensions:
Wheel bolts: M6
Length mounting surface: 150mm
Height mounting surface - axle center: 56 mm
Total height: 87 mm
Diameter wheell: 62,5 mm
Width wheel: 20 mm
Mounting screws Ø: 5mm
Mounting screws length: 30mm
Distance between mounting holes: 39mm

There is a slight mounting angle difference between the left and right wheel, which makes sure that when the wing is at rest on the ground (on either side) the wheel is positioned 90 degrees in correlation to the ground. So that their is no shearing load.

For the installation of the wheels the included screws can be used.
If an installation with screws is not suitable for you, the wheels can also be easily attached to the wing using our HPX tape (HT1902), which proves strong(er) than enough.
This tape can also serve to fill every shape of wing to fit any glider, for example by sticking an extra layer of tape in the middle of the tip wheel.